Followers

Showing posts with label velocity. Show all posts
Showing posts with label velocity. Show all posts

Friday, September 11, 2026

Continuity equation calculator

Continuity Equation Calculator | Fluid Mechanics

Continuity Equation Calculator

Volumetric Flow Rate, Fluid Velocity, and Flow Area

How to Use This Tool

  1. Select the variable you want to calculate: flow rate (Q), velocity (V), or flow area (A).
  2. Enter the two known quantities using MKS units: m³/s, m/s, or m².
  3. The result is calculated automatically as you enter valid data. You may also press the Calculate button.
  4. The calculated value is displayed in MKS, CGS, and British (Imperial) units.
  5. Negative values are not permitted, and division by zero is prevented.

Governing Equation

\[ Q = V \times A \]

\(Q\) = volumetric flow rate, \(V\) = average fluid velocity, and \(A\) = cross-sectional flow area.

Equation for selected calculation: \(Q = V \times A\)

Calculator

Enter the two known quantities in MKS units.

Results and Unit Conversions

Volumetric Flow Rate (Q)
— m³/s
Unit System Value Unit
MKS (SI) — m³/s
CGS — cm³/s
British (Imperial) — ft³/s

Conversion factors: 1 m³/s = 10⁶ cm³/s = 35.3146667 ft³/s; 1 m/s = 100 cm/s = 3.2808399 ft/s; 1 m² = 10⁴ cm² = 10.7639104 ft².

Thursday, September 10, 2026

Schedule 40 commercial steel pipe geometric data

Schedule 40 Commercial Steel Pipe Geometry

Author: Javier Novo Date: September 2026 Reference: Applied Fluid Mechanics (R. Mott)

📖 User Instructions

1. Select the desired Nominal Diameter (ND) from the dropdown menu.

2. The tool will automatically retrieve and calculate geometric properties in both British (Imperial) and MKS (SI) units.

3. Review the cross-section diagram and LaTeX equations for verification and homework documentation.

📊 Geometrical Data

British / Imperial Units

PropertyValue (in)Value (ft)
Outside Diameter (Do)--
Inside Diameter (Di)--
Wall Thickness (t)--
Flow Area (A)--

MKS / SI Units

PropertyValue (mm)Value (m)
Outside Diameter (Do)--
Inside Diameter (Di)--
Wall Thickness (t)--
Flow Area (A)--

📐 Pipe Cross-Section Sketch

🧮 Governing Equations

Wall Thickness relationship:

$$t = \frac{D_o - D_i}{2}$$

Cross-sectional Flow Area:

$$A = \frac{\pi}{4} D_i^2$$

Schedule 80 steel pipe data finder based on the ND

Schedule 80 Steel Pipe Data Finder

Prepared by Luis Mario Chávez Jurado

Date completed: September 6, 2026


Please select the nominal diameter (in) you want to look up from the buttons below.

Nominal diameter (in):

Formulas used

— flow area from the internal diameter
— flow rate from velocity and area
Minimum and maximum allowable velocities, and their corresponding minimum and maximum flow rates, are based on the "General Service" velocity criteria table from Crane Technical Paper No. 410, Flow of Fluids Through Valves, Fittings, and Pipe.

Ideal gas mole calculator - SI

Ideal Gas Mole Calculator Created by: Nayomi Alvarez Contreras Date: November 15, 2026 Desc...